Veikong VFD500 Series User Manual page 125

Chapter 5 Function code
Function
Parameter name
code
No-warranty
P58.04
setting
r58.05
Fire mode status
DI function: 57 fire signal input
DO function: 45 fire status output
Parameter Modification Method for 380V Inverter Using 220V Power Supply：
P00.16=2048，enter agency authority
Modify the following two parameters to make it lower than the actual power supply voltage, it can run normally!
P22.21：Soft start relay pull-in voltage, unit: V
P60.00 Control mode
P60.01 Upper limit frequency
Upper limit frequency
P60.02
digital setting
Accel and Decel time
P60.04
option
Accel time frequency
P60.05
switchover 2
Decel time frequency
P60.06
switchover 2
VFD500 high performance vector control frequency inverter user manual
Description
If the continuous running time in fire mode
exceeds this setting, P58.02 will be set to 1,
time and the VFD is out of warranty. The
keyboard displays
parameter to 0 to clear the no-warranty
mark.
When P58.00≠0
corresponding to the DI-57 function is valid,
this flag is set to 1.
It is used to indicate whether it is currently
working in a fire state.
60 Group Motor 2 basic parameter
Same as P00.04
Same as P01.07
Lower limit (P01.09) ～
frequency(P01.06)
0：same as motor 1
1：Accel and Decel time 3
When choose 1,Motor 2 can convert
between accel and decal time 3 and 4 by
DI terminal function code 55 or switch by
output frequency comparing with P60.05
P60.06）
0.00Hz～maximum frequency (P01.06)
0.00Hz～maximum frequency(P01.06)
61 Group Motor2 parameter
61.xx same as motor 1 parameter P11.xx
62 Group Motor 2 VF control parameter
62.xx same as motor 1 VF control P12.xx
63 Group Motor 2 Vector control parameter
63.xx same as motor 2 Vector control P13.xx
- 123-
Default
300s
A.FirE. Set this
and the terminal
0
maximum
50.00Hz
0.00Hz
0.00Hz
Property
RW
RO
0
★
0
★
☆
0
★
☆
☆