Veikong VFD500 Series User Manual page 114

Chapter 5 Function code
Function
Parameter name
code
Sleep setting value by
P41.01
frequency
When selecting frequency sleep and frequency wake-up, it must be set by P41.01 < P41.02. When the frequency
source is PID setting, and the frequency wake-up must be set to PID shutdown operation: P40.39 = 1.
Sleep setting value by
P41.03
pressure
Wake up threshold by
P41.04
pressure
P41.05 Sleep delay time
P41.06 Wake up delay up
Sleep decelerating
P41.07
time
PLC current running
r42.00
mode
PLC current running
r42.01
remaining time
r42.02 PLC times of cycles
Simple PLC running
P42.03
mode
VFD500 high performance vector control frequency inverter user manual
Description
0.00Hz～600HZ,It will sleep if value is less
than this value
0～100.0%
0.～100.0%
0.0s～6000.0s
0.0s～6000.0s
Setting value decide by P03.16
P03.16 = 2, 0.00～600.00s;
P03.16 = 1, 0.0s～6000.0s;
P03.16 = 0, 0s～60000s
P41.07 set to 0,sleeping stop mode to free
coast.
42 Group Simple PLC
Read only
Read only
Read only
Unit'digit:
0: single cycle then stop
1: single cycle then keep last speed
2: recycle
3: Plc reset when single cycle stop
Ten's digit:
0:power off without saving
1:power off with saving
Hundred'digit:
0:stop without saving
1:stop with saving
0: Restart from the first stage; stop during
running (cause by the stop command, fault
or power loss), run from the first stage after
restart. 1: Continue to run from the stop
frequency; stop during running(cause by
stop command and fault), the inverter will
record the running time automatically, enter
into the stage after restart and keep the
remaining running at the setting frequency.
- 112-
Default Property
0.00Hz
☆
0.0%
☆
0.0%
☆
0.0s
☆
0.0s
☆
0.00s
☆
●
-
●
-
●
-
003
☆