Veikong VFD500 Series User Manual page 168

VFD500 high performance vector control frequency inverter user manual Appendix B Profinet communication card usage
5.8 Profinet communication card directly replace the settings
When the inverter fails to replace, the inverter can be replaced directly, and the communication
card can be reinstalled and the parameters can be set. However, if the Profinet communication
card is replaced, it needs to be reconfigured, and if you want to configure direct replacement, you
need to set it accordingly.
Note: In order to directly replace the communication card, the replacement device and the
replaced device must be MT500-profinet communication card, and other manufacturers
cannot replace it directly.
There are two methods for direct replacement：
Set the device name and I address in the drive, do not pay attention to the actual
1.
network topology, only need to ensure that the device name and IP address are
correct.
2. The IP address and device name are not set in the drive, and the host computer is
set according to the following method.
When the drive is not set with the IP address and device name, the host computer settings
for quick replacement are realized：
1.Switch the network view, select the master network interface, in the "Properties" -> "General"
- > "Advanced Options" below, check "Support device replacement without replaceable media"
and "Allow overwriting all allocated IO device names", if you do not check "Allow overwriting all
allocated IO device names", when the replacement device has been assigned a device name, it
.
cannot be replaced
2.Switch to the topology view, click the port with the mouse, hold it, then move the mouse to
- 166-