Table of Contents
Advertisement
Memory speed tables
For specific DDR4 server memory speeds, for HPE servers using AMD processors, see the Hewlett Packard Enterprise
website (http://www.hpe.com/docs/amd-speed-tables).
Installing a DIMM
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Extend the server from the rack.
•
•
Remove the server from the rack.
5.
Remove the access panel.
6.
Install the DIMM:
a. Open the DIMM slot latches.
b. Align the notch on the bottom edge of the DIMM with the keyed surface of the DIMM slot, and then fully press
the DIMM into the slot until the latches snap back into place.
The DIMM slots are structured to ensure proper installation. If you try to insert a DIMM but it does not fit easily
into the slot, you might have positioned it incorrectly. Reverse the orientation of the DIMM and insert it again.
7.
Install the access panel.
8.
Install the server into the rack.
Hardware options installation
83
Advertisement
Table of Contents
