Installing A Dimm Blank - HPE ProLiant DL380 Gen10 Plus User Manual

Installing a DIMM blank

Installing a DIMM blank
About this task About this task
Use the following table to decide if the thermal restrictions of the server require DIMM blanks in all open slots of your configuration.
Processor TDP Processor TDP DIMM blank installation DIMM blank installation
105W to 140W Recommended
230W to 270W Recommended
150W to 270W Required
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Open the DIMM slot latches.
6. Install the DIMM blank.
Installing a DIMM blank 114