Table 59: "Ramp Settings" Menu Item - WAGO 750-632 Manual

94 Commissioning

Table 59: "Ramp Settings" Menu Item

Option
Ramp Selection
Nominal Value Ramp
Parameters
Jog Mode Ramp
Rising/Falling
Stop Mode Ramp
Rising/Falling
Process Data Ramps
Ramp 1 – Ramp 5
Rising/Falling
End Stop Behavior
Behavior
End stop value
Power Amp Off *
Use ramp
* Function supported in software version 03 or higher.
Manual
Version 1.3.1, valid from FW/HW-Version 01/01
Description
The selection of a ramp here can also be changed using the "Operation"
menu item.
This ramp is a fixed ramp. This selection cannot be changed using the
"Operation" menu item.
The ramp gradient can be defined here.
The ramp gradient can be defined here.
The gradients for individual ramps can be defined here.
The end stop behavior can be selected. The following can be selected for
this:
• Hold current value
• Approach end stop value with stop ramp.
• Approach end stop value with ramp 1.
• Approach end stop value with ramp 2.
• Approach end stop value with ramp 3.
• Approach end stop value with ramp 4.
• Approach end stop value with ramp 5.
The end stop value can be entered in percent.
If the checkbox is selected, the configured substitute value is approached
via the stop ramp. If the output stage is off, the actual value is moved to
"Zero" via the stop ramp.
WAGO I/O System 750/753
750-632 Proportional Valve Module