Function Block: Linearization; Figure 23: Start Up Ramp 100% In 10,000 Ms; Figure 24: Function Block: Linearization; Table 37: Reference Values For Ramps - WAGO 750-632 Manual

58 Function Description

Figure 23: Start up Ramp 100% in 10,000 ms

Table 37: Reference Values for Ramps

Procedure
Direct specification
of setpoint value
Setup mode
Dithering
5.5.2

Function Block: Linearization

This function block is used to compensate for static nonlinearities within the
connected valve. For this purpose, up to 20 supporting points can be defined, by
means of which the characteristic curve can be gradually approximated. A
supporting point consists of an x-coordinate and a y-coordinate. The supporting
points are designated as "P1 ... P20" and can be set in a table ( see section 9)

Figure 24: Function Block: Linearization

Manual
Version 1.3.1, valid from FW/HW-Version 01/01
Rising Ramps
4
1
1
WAGO I/O System 750/753
750-632 Proportional Valve Module
Falling Ramps
4
1
1
Reference Value
Nominal current
Nominal current
Nominal current for
dithering