Removing The I/O Module; 750-632 Proportional Valve Module; Figure 30: Inserting I/O Module (Example); Figure 31: Snap The I/O Module Into Place (Example) - WAGO 750-632 Manual

WAGO I/O System 750/753

750-632 Proportional Valve Module

Figure 30: Inserting I/O Module (Example)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 31: Snap the I/O Module into Place (Example)

3. Check that the I/O module is seated securely on the carrier rail and in the
assembly. The I/O module must not be inserted crooked or askew.
Once the I/O module has snapped into place, the electrical connections for the
data contacts and power contacts (if any) to the head station or to the preceding
and, if applicable, following I/O module are established.
7.2.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.
Version 1.3.1, valid from FW/HW-Version 01/01
Mounting 73
Manual