WAGO I/O System 750/753
750-632 Proportional Valve Module
The Control nibble is used to transfer a request while the Status nibble contains
the response to the request.
11.1.3.1.1 Mailbox Commands
The following commands are defined:
Table 66: Commands
Value
0
1
2
3 ... 7
11.1.3.1.2 Acknowledgement
The following acknowledgements are defined:
Table 67: Acknowledgement
Value
0
1
2
3 ... 7
Explanation
INVALID
HOLD REQUEST
RESET REQUEST
-
Explanation
INVALID
HOLD
ACKNOWLEDGE
RESET
ACKNOWLEDGE
-
Description
Signals that the sender has not started operations
again after a reset.
Notice that the channel is ready, but data is not
currently being transferred (e.g. because the
output buffer is still empty).
Prompt to reset
(not supported, ignore)
Description
Signals that the receiver has not started operations
again after a reset.
Signal or confirmation that the channel is ready,
but data is not currently being transferred (e.g.
because there is not any data yet).
Response to "RESET REQUEST" when Mailbox in
reset.
(not supported, ignore)
Version 1.3.1, valid from FW/HW-Version 01/01
Appendix 109
Manual