WAGO 750-632 Manual page 46

46 Function Description
Change the setpoint manually!
The end stop value must be reached before the setpoint can be manually
changed in JOG mode!
Configuring the end stop value correctly!
The I/O module does not consider whether the end stop has been configured
correctly. If the end stop value is too large, for example, the permitted maximum
value may be exceeded. If the end stop value exceeds the permitted maximum
value, a "Single Shot" is generated as a warning and transmitted to the fieldbus
controller via Mailbox 2.
Manual
Version 1.3.1, valid from FW/HW-Version 01/01
WAGO I/O System 750/753
750-632 Proportional Valve Module