Channel-Dependent Parameters; Tables 50, 51 (Process Data Handling, Valve 1, Valve 2); Table 85: Parameters, Table 50 (Process Data Handling, Valve 1) - WAGO 750-632 Manual

126 Appendix
11.4.2.1

Channel-Dependent Parameters

11.4.2.2

Tables 50, 51 (Process Data Handling, Valve 1, Valve 2)

Tables 50 and 51 are configured identically. As an example, Table 50 will be
explained for Valve 1 here.

Table 85: Parameters, Table 50 (Process Data Handling, Valve 1)

Register Name,
1
2
3
4
5
6
7
8
Manual
Version 1.3.1, valid from FW/HW-Version 01/01
Bits
Type Explanation
PH_SUBST_ 0
STRA, substitute value
BOOL strategy
PH_SUBST_ 0 ... 15
CURR,
INT16
PH_TIP_ 0
MODE,
BOOL
PH_TIP_TIME, 0 ... 15
UINT16
PH_TARGET_ 0 ... 15
WINDOW,
UINT16
PH_ENDSTOP 0 ... 2
_FUNCTION,
INT16
PH_ENDSTOP 0 ... 15
_CURRENT,
INT16
WAGO I/O System 750/753
750-632 Proportional Valve Module
Value/Range Description
(Default)
0 Output last value from the
process image.
1 Output value according to
PH_SUBST_CURR.
-10000 ... Substitute value for the output
+10000 current.
One LSB corresponds to 0.01%
of the maximum current.
0 JOG mode if activated in C1
1 TIP mode if activated in C1
0 ... 65535 In TIP mode, the current
(Default: 100) increases according to the ramp
set, but according to the
maximum amount for the
duration set in PH_TIP_TIME
[Output in ms].
100 Window for status bit
ON_TARGET in % around the
setpoint; ON_TARGET is set if
the internal output value is
within the window around the
setpoint.
(Default: 18) (reserved)
0 ... 6 End stop behavior:
(Default: 0) 0 Hold current value.
1 Approach end stop value
with stop ramp.
2 Approach end stop value
with ramp 1.
3 Approach end stop value
with ramp 2.
4 Approach end stop value
with ramp 3.
5 Approach end stop value
with ramp 4.
6 Approach end stop value
with ramp 5.
-10000 ... End top value to be approached;
+10000 One LSB corresponds to 0.01%
(Default: 0) of the permitted maximum
current.