Table; Table 84: Parameter, Table 32 (Module Monitoring) - WAGO 750-632 Manual

WAGO I/O System 750/753
750-632 Proportional Valve Module
Table 83: Parameters, Table 33 (DI1)
Register Name,
11.4.1.5 Table 40 (Additional Module Parameters

Table 84: Parameter, Table 32 (Module Monitoring)

Register Name,
0
Bits
Type Explanation
Bits
Type Explanation
PWR_EN_USE_ 0
STOPRAMP,
UINT16
Value/Range Description
(Default)
3 HOLD Valve 1
Maintains current setpoint value.
Note:
This function is state-controlled:
•
•
4 Jog + Valve 1
OR function using control bit 7
for Valve 1
Jog - Valve 1
5
OR function using control bit 6
for Valve 1
Jog + Valve 2
6
OR function using control bit 7
for Valve 2
7 Jog - Valve 2
OR function using control bit 6
for Valve 2
8 ... 255 (reserved)
Value/Range Description
(Default)
0 ... 1 Use stop ramp to disable the
(Default: 0) output stages. Use stop ramp to
approach the substitute value.
Version 1.3.1, valid from FW/HW-Version 01/01
Appendix 125
If the input is activated, the
"HOLD" function is also
activated. The setpoint
value cannot be
approached.
If the input is deactivated,
the "HOLD" function is also
deactivated. The current
setpoint value is
approached.
Manual