Erasing Peripheral Shadows On The Image (Erase) - Sharp DX-C310 Operation Manual

ERASING PERIPHERAL SHADOWS ON THE IMAGE (Erase)

The erase function is used to erase shadows on images produced when scanning thick originals or books. (This function
does not detect shadows and will eliminate everything appearing in the erase area - including shadows, text and images.)
Scanning a thick book
Shadows appear here
Erase modes
• Shadows at the edges of the original can also be erased when the automatic document feeder is used.
• When using USB memory mode, connect the USB memory device to the machine before performing the procedure below.
Keys in the display can be selected with the arrow keys and the [OK] key.
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
1
When the original is a different size than the size setting, set the original size.
☞
SPECIFYING THE ORIGINAL SCAN SIZE AND SEND SIZE
Specify the destination.
☞
ENTERING DESTINATIONS
2
When scanning to USB memory, there is no need to specify the destination. Go to step 3.
Select the special modes.
(1) Select the [Mode Switch] key.
(2) Select the mode that you wish to use.
3
(3) Select the [Special Modes] key.
(4) Select the [Erase] key.
☞
SPECIAL MODES
Edge Erase
(page 5-22)
(page 5-77)
Not using the erase
function
Shadows appear in the
image.
Side Erase
(page 5-61)
5-91
SCANNER/INTERNET FAX
Using the erase
function
No shadows appear.
Contents