Sharp DX-C310 Operation Manual page 379

(2)
3
(3)
Press the [BLACK & WHITE START] key to scan the first set.
4
To cancel scanning...
Press the [STOP] key (
Insert the next set of originals and press the [BLACK & WHITE START] key.
Repeat this step until all originals have been scanned.
5
To cancel scanning...
Press the [STOP] key (
6
• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
• The [Configure] key can be selected to change the exposure, resolution, scan size, and send size for each original
page scanned.
• If the memory becomes full during scanning, a message will appear and the transmission will be canceled.
• This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel Job Build....
Set the [Job Build] checkbox to
Select job build mode.
(1) Select the [Special Modes] key.
BACK OK
(2) Set the [Job Build] checkbox to
(3) Select the [Basic Menu] key.
).
). All scanned data will be cleared.
Select the [Read-End] key.
BACK OK
in the screen of step 3.
4-86
☞
SPECIAL MODES (page 4-69)
FACSIMILE
.
Contents