Table of Contents
Advertisement
ERASE
This copier has an edge erase function and a centre erase function.
Edge erase can be used to eliminate shadow lines around the
edges of copies caused when thick paper or a book is used as an
original.
Centre erase can be used to eliminate the shadow produced by
the bindings of bound documents.
KEY OPERATOR The width for edge erase and centre erase can be
changed. See page 16 of the KEY OPERATOR'S GUIDE. The initial
setting of the erase mode can also be changed. See page 18 of the KEY
OPERATOR'S GUIDE.
A
A B
ERASE
CHANGE
1
2
5
4
7
8
AUDIT
0 /
CLEAR
22
Downloaded from:
http://www.usersmanualguide.com/
A
A B
1
2
COVERS INSERTS
TRANSPARENCY
INSERTS
3
3
6
4
START
I
I
Edge erase
Centre erase
Place the originals face down in the RADF tray or on
the document glass.
Press the ERASE key.
The message "EDGE ERASE" , "CENTER ERASE" or both will
be highlighted in the message display.
If a change in the erase mode is required, press the CHANGE
key and then select the desired erase mode by pressing key 1,
2, or 3 on the 10-key pad. (1: EDGE ERASE, 2: CENTER
ERASE, 3: EDGE+CENTER ERASE)
The erase feature applies to the copy paper when using the
document glass and therefore the erased image portion of the
copy can be shifted with repositioning of the original.
Enter the desired number of copies.
Press the START key.
Advertisement
Table of Contents
