Table of Contents
Advertisement
SENDING AN IMAGE IN USB MEMORY MODE
Follow the steps below to send a scanned image to a commercially available USB memory device that has been
connected to the machine. This stores the file in the USB device.
• Use a FAT32 USB memory with a capacity of no more than 32 GB.
• When a default address is configured in "Default Address Setting" (Web page only) in the system settings (administrator),
the mode cannot be changed. To switch to USB memory mode, select the [Cancel] key in the display, press the [OK] key,
and follow the steps below.
Keys in the display can be selected with the arrow keys and the [OK] key.
1
• When placing the originals, orient them as shown below.
Originals
Portrait orientation*
2
1
Landscape orientation
1
* To place a large portrait-oriented original, place it as shown above in "Landscape orientation" and specify the
placement orientation in step 4.
• Originals cannot be scanned in succession from both the automatic document feeder and the document glass and
sent in a single transmission.
Connect the USB memory to the USB
connector (Type A) on the machine.
Place the original.
Document feeder tray
Place the original face up.
1
5-39
SCANNER/INTERNET FAX
Document glass
Place the original face down with the middle
aligned with the tip of the
the scale on the left side of the document glass.
1
mark at the middle of
Contents
Advertisement
Chapters
Table of Contents
