Fax Data Receive/Forward; Fax Settings - Sharp DX-C310 Operation Manual

Item
Items displayed when storing a relay broadcast memory box
Recipients
• When programming a new memory box, a sub-address that is already programmed for another box cannot be used.
However, the same passcode can be used for more than one memory box.
• A passcode can be omitted.
• [ ] and [#] cannot be used in a sub-address.
• Do not forget the Print PIN.

Fax Data Receive/Forward

This section explains settings for reception and forwarding. Select [System Settings] - [Fax Data Receive/Forward] from
the menu bar and configure each setting.

Fax Settings

The following items appear when the "Fax Settings" are configured.
Item
Receive Setting
Multiple Set Print
Staple
If "Hold Setting for Received Data
password with the numeric keys.
Select the end recipients of the relay broadcast. Select the recipients from the
address book.
• Direct Entry: An address that is not stored in the address book can be
directly entered. Enter the address in the same way as when
storing an address for a mode.
• Address Review: This displays a list of the selected recipients. Addresses can
be deleted from this list if needed.
Set the fax reception method.
• Auto Reception:
• Manual Reception: This can be used when an existing extension phone is
Specify whether or not two or more copies of received faxes will be printed. The
number of copies is set in
Specify whether or not stapling is performed. (Only when a finisher is installed.)
Print" (page 6-35) is enabled, you will be prompted to enter a password. Enter the correct
6-108
WEB PAGE - FAX (GENERAL)
Description
Description
When a call comes in, the machine rings and then
automatically begins fax reception.
connected to the machine. Fax reception is begun by
manual operation after answering on the extension phone.
"Fax Output Settings", (page 6-115).
SYSTEM SETTINGS
Contents