Using A Program To Send - Sharp DX-C310 Operation Manual

USING A PROGRAM TO SEND

Keys in the display can be selected with the arrow keys and the [OK] key.
Place the original.
Place the original in the document feeder tray or on the document glass as appropriate for the functions stored in the
1
program.
When the original is a different size than the size setting, set the original size.
☞
SPECIFYING THE SCAN SIZE AND SEND SIZE
Select the special modes.
(1) Select the [Special Modes] key.
2
(2) Select the [Program] key.
☞
SPECIAL MODES
Program 1
3
Program 2
Program 3
Program 4
Program 5
4
• The screen that appears will vary depending on the destination stored in the program.
• The mode cannot be changed here.
• Functions stored in the program cannot be canceled here.
Press the [BLACK & WHITE START] key.
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
5
When scanning finishes, place the next original and press the [BLACK & WHITE START] key. Repeat until all pages have
been scanned and then select the [Read-End] key.
A beep will sound to indicate that scanning is finished.
To cancel scanning...
Press the [STOP] key (
(page 4-69)
BACK OK
).
(page )
4-50
Retrieve the stored program.
Select the desired program key.
Select additional settings.
When a program is used, the following settings can be
additionally specified:
• Image settings: Original scan size*, send size
• Special modes: Timer Transmission, Card Shot, Own Name
Select, Transaction Report
* When stored in the program, this cannot be additionally
specified.
4-73
FACSIMILE
Contents