Sharp DX-C310 Operation Manual page 89

1
When closing the automatic document feeder, take care that your fingers do not become pinched.
2
Indicator
line
3
• Do not insert your hand into the document insertion opening in the automatic document feeder.
• If originals are placed higher than the line, misfeeds may occur.
• Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips.
• If originals have damp spots due to correction fluid, ink or pasteup glue, wait until the originals are dry before making
copies. Otherwise the interior of the document feeder or the document glass may be soiled.
• When using originals with two or three holes, place them so that
the punched edge is at a position away from the feed slot of the
document feeder tray.
BEFORE USING THE MACHINE
Make sure an original does not remain
on the document glass.
Open the automatic document feeder, make sure that an
original is not on the document glass, and then gently close the
automatic document feeder.
Adjust the original guides to the size of
the originals.
Place the originals.
Make sure the edges of the originals are even.
Insert the originals face up all the way into the document feeder
tray.
Insert a number of originals that does not exceed the indicator
line on the document feeder tray.
Up to 50 sheets can be inserted.
Be sure to remove originals that have been finished scanning
from the original exit tray.
Feed slot
1-51
Hole
positions
Contents