Copy Settings - Sharp DX-C310 Operation Manual

Copy Settings

Click the [Copy Settings] tab and configure the settings.
Copy Exposure Adjustment
This is used to adjust the exposure level when [Auto] is
used for the copy exposure.
Color
Use this to set the copy exposure level in color mode for the
document glass and for the automatic document feeder.
Black & White
Use this to set the copy exposure level in black & white
mode for the document glass and for the automatic
document feeder.
Add or Change Extra Preset Ratios
Two enlargement preset ratios (101% to 200%) and two
reduction preset ratios (50% to 99%) can be added. An
added preset ratio can also be changed.
Preset ratios other than added preset ratios cannot be
changed.
Setting a Maximum Number of Copies
This is used to set the maximum number that can be
entered for the number of copies (number of continuous
copies). Any number from 1 to 999 can be specified.
Initial Margin Shift Setting
This is used to set the default margin shift amount.
Specify a value from 0" (0 mm) to 1" (20 mm) in
increments of 1/8" (1 mm) for both the front and reverse
sides.
Erase Width Adjustment
This is used to set the default erase width for erase
copy. Specify a value from 0" (0 mm) to 1" (20 mm) in
increments of 1/8" (1 mm) for edge erase.
Card Shot Settings
This is used to set the default original size for the card
shot function.
Both the X (horizontal) and Y (vertical) dimensions of the
original can be set from 1" (25 mm) to 8-1/2" (210 mm) in
increments of 1/8" (1 mm).
Fit to Page
Enable this setting to have the [Fit to Page] key always
appear in the card shot screen.
Disabling Deletion of Job Programs
This is used to prohibit the deletion and changing of copy
settings stored in job programs.
Disabling of Bypass-Tray in
Duplex Copy
This is used to prohibit the use of the bypass tray when
making two-sided copies.
The bypass tray is often used to feed label sheets,
transparency film, and other special media for which
two-sided copying is prohibited. If a sheet of one of these
special media enters the reversing unit, a misfeed or
damage to the unit may result. If special media for which
two-sided copying is prohibited is often used, it is
recommended that you enable this setting.
Disabling of Auto Paper Selection
This setting is used to disable the Auto Paper Selection
function.
When this is enabled and an original size is set, the
same size of paper is not automatically selected.
Auto Selection of Paper Tray that
was Last Loaded
When this setting is enabled and the machine is on
standby in copy mode, the last paper tray that was
loaded with paper automatically becomes the default
paper tray for copy mode, until the machine is reset.
6-75
SYSTEM SETTINGS
WEB PAGE (ADMINISTRATOR)
Contents