Device Control; Original Feeding Mode; Disabling Of Duplex; Disabling Of Document Feeder - Sharp DX-C310 Operation Manual

Device Control

These settings control devices installed on the machine. Select [System Settings] - [Device Control] from the menu bar
and configure each setting.
AB/Inch Type Setting
The numbers and units of the default settings and input
ranges that appear in the setting screens can be
switched between inches and AB sizes.
Default Original Size Settings
Specify this setting when a particular original size is
frequently used. The setting will appear in the [Original]
key.
Specifying this setting allows the original size setting to
be omitted.
Mode
Copy None, A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K
Image Send None, A5, B5, A4,
216mm x 330mm (8-1/2" x 13"),
8-1/2" x 13-2/5" (216mm x 340mm),
216mm x 343mm (8-1/2" x 13-1/2"),
8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2",
16K, Long Size
When [None] is selected, the original size does not
appear and must always be set manually.

Disabling of Document Feeder

Use this setting to prohibit the use of the automatic
document feeder, such as when the feeder malfunctions.
(When the setting is enabled, scanning is still possible
using the document glass.)
Settings
6-72
WEB PAGE (ADMINISTRATOR)

Original Feeding Mode

The following original feeding modes can be set to
operate by default in copy, and image send modes.
When a mode is frequently used, this saves you from
having to select the mode in the special modes each
time you need to use it.
• Mixed size originals of the same width (Copy mode
only)
• Slow Scan Mode

Disabling of Duplex

This is used to disable two-sided printing, such as when
the duplex module malfunctions.
Disabling of Optional Paper Feed
Unit
(When a 500-sheet paper feed unit is installed.)
This setting is used to disable a 500-sheet paper feed
unit, such as when it malfunctions.
Disabling of Tray Settings
This setting is used to prohibit tray settings (except for
the bypass tray).
Disabling of Offset
(When a finisher is installed.)
This setting is used to disable the offset function.

Disabling of Stapler

(When a finisher is installed.)
This setting is used to prohibit stapling, such as when
the stapler unit of the finisher malfunctions.
SYSTEM SETTINGS
Contents