Sharp DX-C310 Operation Manual page 506

4
(3)
When this screen is opened, the setting will show the current time. If the time is not correct, press the [CLEAR ALL] key
( ) to cancel the operation. Correct the time in the system settings and then perform the timer transmission procedure.
☞
CHECKING THE DATE AND TIME
Press the [COLOR START] key or the [BLACK & WHITE START] key.
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
When scanning finishes, place the next original and press the [COLOR START] key or the [BLACK & WHITE START] key.
Repeat until all pages have been scanned and then select the [Read-End] key.
5
A beep will sound to indicate that scanning is finished.
• If the destination is an Internet fax destination, press the [BLACK & WHITE START] key.
• The original is scanned into memory. The original cannot be scanned at a specified time.
To cancel scanning...
Press the [STOP] key (
• The time can be specified up to a week in advance.
• Up to 94 timer transmissions can be stored at once.
• If another transmission is in progress when the specified time arrives, the timer transmission will begin after that
transmission is finished.
• Other transmissions can be performed as usual after a timer transmission is stored.
• A timer transmission can be deleted in the job status screen.
• If a timer transmission is given priority in the job status screen, the time specification is canceled. The transmission will
begin as soon as the job in progress is completed.
☞
GIVING PRIORITY TO A SCAN TRANSMISSION JOB
To cancel timer transmission...
Select the [Cancel] key in the screen of step 4.
Set the time with the
(1)
(1) Specify the day.
BACK OK
(2) Specify the time (hour, minute)
(2)
(3) Select the [Basic Menu] key.
BACK OK
(page 5-5)
) to cancel the operation.
(page 5-107)
5-84
SCANNER/INTERNET FAX
If you do not wish to specify a day, select [---]. In this
case, transmission will begin when the time specified in
(2) arrives.
Select the time in 24-hour format.
You can also select a numeric display key to change the
setting with the numeric keys.
keys.
Contents