Custom Size Registration (Bypass); Paper Type Registration; Fax Data Receive/Forward; I-Fax Settings - Sharp DX-C310 Operation Manual

Custom Size Registration (Bypass)

If you frequently use a special non-standard paper size in the bypass tray, you can store that paper size.
Storing the paper size saves you the trouble of setting the size each time you need to use it.
Up to three paper sizes can be stored.
Select whether you wish to enter the size in inches ("Size Input-Inch") or mm ("Size Input-AB"), and then set the X and Y
dimensions of the paper.
"Size Input-Inch"
The X dimension can be set to a value from 5-1/2" to 14". The factory default setting is 11".
The Y dimension can be set to a value from 5-1/2" to 8-1/2". The factory default setting is 8-1/2".
"Size Input-AB"
The X dimension can be set to a value from 140 mm to 356 mm. The factory default setting is 297 mm.
The Y dimension can be set to a value from 100 mm to 216 mm. The factory default setting is 210 mm.

Paper Type Registration

Store a paper type when the desired paper type does not appear as a selection or when you wish to create a new set of
paper properties.
Select [System Settings] - [Paper Type Registration] from the menu bar and configure each setting.
Up to 7 paper types can be stored.
Item
Type Name
Fixed Paper Side
Disable Duplex
Disable Staple
The settings that can be selected vary depending on the peripheral devices installed.

Fax Data Receive/Forward

This section explains settings for reception and forwarding. Select [System Settings] - [Fax Data Receive/Forward] from
the menu bar and configure each setting.
For explanations of settings related to the fax function, see
6-97).

I-Fax Settings

This setting can be configured when the Internet fax expansion kit is installed.
Manual Reception Key in Initial Screen
This displays the [I-Fax Manual Reception] key in the base screen of Internet fax mode.
Store any name.
The factory default names are "User Type 1" - "User Type 7".
Enable this setting when paper with a front and reverse side is used.
Enable this setting when paper is loaded that cannot be used for two-sided printing.
Enable this setting when paper is used that cannot be stapled.
"FAX SYSTEM SETTINGS ON THE OPERATION
6-51
SYSTEM SETTINGS
WEB PAGE (GENERAL)
Description
Contents
PANEL" (page