Tektronix Keithley 2651A Reference Manual page 651

Section 7: TSP command reference
smuX.trigger.source.set()
This function sets the source event detector to the detected state.
Type TSP-Link accessible
Function Yes
Usage
smuX.trigger.source.set()
Details
This function sets the source event detector to the detected state.
The SMU automatically clears all event detectors when the smuX.trigger.initiate() function is
executed. Call this function after the sweep is initiated. If the event detectors are configured to clear
automatically because the smuX.trigger.autoclear attribute is set to smuX.ENABLE, make sure
that smuX.trigger.source.set() is issued after the SMU has entered the trigger layer.
Example
reset()
smua.trigger.source.listv({5})
smua.trigger.source.stimulus = display.trigger.EVENT_ID
smua.source.output = smua.OUTPUT_ON
smua.trigger.initiate()
delay(1)
-- Continue even if the display trigger key was not pressed.
smua.trigger.source.set()
waitcomplete()
Sets the source event detector.
Also see
smuX.trigger.arm.set()
smuX.trigger.autoclear
smuX.trigger.endpulse.set()
smuX.trigger.initiate()
smuX.trigger.measure.set()
Triggering (on page 3-36)
7-306
Model 2651A High Power System SourceMeter® Instrument Reference Manual
Affected by
(on page 7-284)
(on page 7-287)
(on page 7-289)
(on page 7-294)
(on page 7-296)
Where saved Default value
2651A-901-01 Rev. C October 2021