Tektronix Keithley 2651A Reference Manual page 526

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Example
display.clear()
display.settext(localnode.serialno)
Clears the instrument display.
Places the serial number of the instrument on the top line of its display.
Also see
localnode.description
localnode.model
localnode.revision
localnode.showerrors
This attribute sets whether or not the instrument automatically sends generated errors.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
errorMode = localnode.showerrors
localnode.showerrors = errorMode
errorMode
Details
If this attribute is set to 1, the instrument automatically sends any generated errors stored in the error
queue, and then clears the queue. Errors are processed after executing a command message (just
before issuing a prompt if prompts are enabled).
If this attribute is set to 0, errors are left in the error queue and must be explicitly read or cleared.
When using this command from a remote node, replace localnode with the node reference, for
example, node[5].showerrors.
Example
localnode.showerrors = 1
Enables sending of generated errors.
Also see
localnode.prompts
2651A-901-01 Rev. C October 2021
(on page 7-173)
(on page 7-175)
(on page 7-180)
Affected by
Power cycle
Show error setting:
▪
Show errors: 1
▪
Do not show errors: 0
(on page 7-177)
Section 7: TSP command reference
Where saved Default value
Not saved 0 (disabled)
7-181