Tektronix Keithley 2651A Reference Manual page 512

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Also see
Digital I/O (on page 3-92)
TSP-Link system expansion interface
lan.trigger[N].overrun
This attribute contains the overrun status of the LAN event detector.
Type TSP-Link accessible
Attribute (R) Yes
Usage
overrun = lan.trigger[N].overrun
overrun
N
Details
This command indicates whether an event has been ignored because the event detector was already
in the detected state when the event occurred.
This is an indication of the state of the event detector built into the synchronization line itself. It does
not indicate if an overrun occurred in any other part of the trigger model, or in any other construct that
is monitoring the event.
It also is not an indication of an output trigger overrun. Output trigger overrun indications are provided
in the status model.
Example
overrun = lan.trigger[5].overrun
print(overrun)
Checks the overrun status of a trigger on LAN5 and outputs the value, such as:
false
Also see
lan.trigger[N].assert()
lan.trigger[N].clear()
lan.trigger[N].stimulus
lan.trigger[N].wait()
2651A-901-01 Rev. C October 2021
(on page 6-56)
Affected by
LAN trigger N clear
LAN trigger N reset
Instrument reset
Recall setup
The trigger overrun state for the specified LAN packet (true or false)
The LAN event number (1 to 8)
(on page 7-161)
(on page 7-161)
(on page 7-170)
(on page 7-171)
Section 7: TSP command reference
Where saved Default value
Not applicable Not applicable
7-167