Tektronix Keithley 2651A Reference Manual page 629

Section 7: TSP command reference
smuX.trigger.arm.set()
This function sets the arm event detector to the detected state.
Type TSP-Link accessible
Function Yes
Usage
smuX.trigger.arm.set()
Details
The SMU automatically clears all the event detectors when the smuX.trigger.initiate()
function is executed. Call this function after the sweep is initiated.
A typical example that uses this function is when you want the SMU to immediately perform an action
the first time through the trigger model, even if a programmed trigger event does not occur.
This function start actions on the SMU if a missed trigger event is missed.
Example
smua.trigger.arm.set()
Sets the arm event detector to the detected state.
Also see
smuX.trigger.initiate()
smuX.trigger.measure.set()
smuX.trigger.source.set()
7-284
Model 2651A High Power System SourceMeter® Instrument Reference Manual
Affected by
(on page 7-294)
(on page 7-296)
(on page 7-306)
Where saved Default value
2651A-901-01 Rev. C October 2021