Chapter 1
Connecting the ViewStation SP to an Ethernet LAN
© Polycom, Inc.
Note
If you connect less than three ISDN lines to the Triple BRI
network interface module, the status indicators shown on
the TV monitor are displayed in red.
For more ISDN information, refer to the Appendix D, "ISDN
Information," on page 151.
ViewStation SP128
Complete the following steps to connect the ViewStation SP128 to
an ISDN network:
1. Connect the green tipped RJ-45 cable to the green RJ-45 port
on the back of the ViewStation SP.
2. Connect the opposite end of the green tipped cable to an ISDN
wall jack.
For more ISDN information, refer to the Appendix D, "ISDN
Information," on page 151.
Once the interface is properly connected, the ViewStation SP is
ready to be configured for EtherNet LAN connectivity.
The following describes how to connect the ViewStation SP to an
Ethernet LAN. Before setting up the ViewStation SP, ensure all the
network connectivity issues are tested and resolved.
ViewStation SP384
Complete these steps to connect the ViewStation SP384 with to an
Ethernet LAN network:
1. Connect the orange tipped RJ-45 cable to the RJ-45 port
labeled LAN on the back of the ViewStation SP.
2. Connect the opposite end of the orange tipped RJ-45 cable with
the orange tip to an Ethernet LAN wall jack.
3. If the LAN wall jack is active, a green light appears on the orange
RJ-45 port on the back of the ViewStation SP384.
5
Getting Started
ViewStation SP User Guide