Polycom ViewStation SP128 User Manual page 70

Chapter 2
ViewStation SP User Guide
The ViewStation SP sends SNMP reports on the following:
• Low battery power in the remote control.
• The system is active (powered on) after a long periods of
inactivity.
• Authentication failure: An attempt has been made to log in as an
administrator with the wrong password.
• Authentication success: The Administrator has logged in
successfully.
• Call failed for reason other than a busy line.
• A user has asked for help from the Technical Assistance Center.
See "Using the ViewStation SP Help," on page 19.
• The ViewStation SP is video call.
• A telephone or video call has disconnected.
User options on the SNMP screen are:
Enable SNMP:
• Checked: Enables SNMP management from an SNMP
console.
• Not Checked: Disables SNMP management.
Administrator Contact Name: Enter the name of the person
responsible for remote management of the system. The default
setting is IT Administrator.
SNMP Console IP Address: Enter the IP address of the SNMP
traps sent by the ViewStation SP. Enter 0.0.0.0 in this field if any
SNMP management console is capable of receiving information
from the ViewStation SP.
Location Name: Enter the location of the ViewStation. This field
defaults to the ViewStation SP system name at your country
name. For example, Shellback At United States.
Community Name: Enter the SNMP management community in
which you want to enable the ViewStation SP. The default setting
name for this field is Public.
System Description: This field displays the type of
videoconferencing device. This field cannot be changed.
52
Optional Configurations
www.polycom.com