Placing A Video Call Manually - Polycom ViewStation SP128 User Manual

Chapter 3
ViewStation SP User Guide

Placing a Video Call Manually

To manually place a video call:
1. From the Main Calling screen, using the ARROW buttons on
the remote control to select the Video Call icon. Press the
SELECT button on the remote control. The Video Phone
screen is displayed.
Figure 3-4. Video Phone Screen
2. On the numeric keypad on the remote control, enter the IP
address or the DNS name or H.320 phone number for the far
site end-point. For example:
• 216.54.148.6 or lobby.austin.polycom.com. (H.323)
• 512 367 2593 (H.320)
Select the desired speed and type of call.
Note For H.320: If the far site end-point if it is within the same PBX
system. Enter the last four digits of its number.
To clear all information in the address field, use the ARROW
buttons on the remote control to select the CLEAR button.
Press the SELECT button on the remote control.
Select the character using the arrow keys, enter the character
by pressing the SELECT button on the remote control.
Call Progress Indictors: The gray call progress indicators on
the lower left side of the screen appear when a video call is
76
Using the ViewStation SP
www.polycom.com