Chapter 1
Initial System Configuration
Setup Common to all ViewStation SPs
ViewStation SP User Guide
ViewStation SP128
Complete these steps to connect the ViewStation SP128 with to an
Ethernet LAN network:
1. Connect the orange tipped RJ-45 cable to the RJ-45 port
labeled LAN on the back of the ViewStation SP128.
2. Connect the opposite end of the orange tipped RJ-45 cable with
the orange tip to an Ethernet LAN wall jack.
3. If the LAN wall jack is active, a green light appears on the orange
RJ-45 port on the back of the ViewStation SP128.
This section explains how to setup the ViewStation SP. Except
where noted, the following section applies to both ViewStation SP
models.
The following is a set of general setup procedures which covers all
ViewStation SP models. Specific information which is unique to each
ViewStation SP is noted.
1. Power on the television monitor and ViewStation SP.
2. On the Welcome screen, select the language used to display
screens and information on the ViewStation SP.
Figure 1-2. ViewStation Select Language Screen
6
Getting Started
www.polycom.com