Control Devices; Configuring Remote Control Behavior - Polycom HDX Series Administrator's Manual

Control Devices

Configuring Remote Control Behavior

You can customize the behavior of the remote control to support the users'
environment.
To configure remote control behavior:
1. Go to System > Admin Settings > General Settings > System Settings >
Remote Control.
2. Configure these settings on the Remote Control screen:
Setting
Keypad Audio
Confirmation
Remote Control
Keypad
Use Non-Polycom
Remote
Channel ID
Description
Specifies whether to play a voice confirmation of numbers
selected with the remote control.
Specifies whether pressing remote control keypad buttons
moves the camera to presets or generates touch tones
(DTMF tones). If this is set to Presets, users can generate
DTMF tones by pressing
on a video screen.
Configures the system to accept input from a
programmable, non-Polycom remote control. In most cases
the Polycom remote works as designed, even when this
feature is enabled. However, try disabling this feature if you
experience difficulty with the Polycom remote. For more
information about Polycom HDX system IR codes, refer to
the Integrator's Reference Manual for Polycom HDX
Systems.
Specifies the IR identification channel to which the Polycom
HDX system responds. The default is 3. For more
information about changing this setting, refer to
the Remote Control Channel
10
on the remote control while
Configuring
ID.
10 - 1