Preset - Polycom ViewStation EX Api Manual

API Guide for ViewStation EX, ViewStation FX, and VS4000

preset

150
Description
This command sets camera presets or goes to the presets for the near or far
camera source. It can also register or unregister the shell session to give
notification when someone sets or goes to presets. You can set and store up
to ten preset camera positions. These ten camera presets can be distributed
across the far camera and up to four near-site cameras.
Syntax
preset <register|unregister|near|far>
preset <near|far> <set|go> <"preset">
Parameter Definition
register Registers the system to give notification when the user
sets or goes to presets.
unregister Disables register mode.
near Specifies the near camera. Requires a set or go
parameter and a "preset" identifier.
far Specifies the far camera. Requires a set or go parameter
and a "preset" identifier.
preset <near|far> Definition
Parameter
set Sets a camera preset. Requires a "preset" parameter.
go Moves the camera to a camera preset. Requires a
"preset" parameter.
"preset" Camera preset identifier. Must be an integer in the
range {0..9}.
Example
preset near set 2
The current location/position of the near end camera is saved as near
preset 2.
www.polycom.com/videodocumentation