What's New In Release 6.0; New Commands - Polycom ViewStation EX Api Manual

API Guide for ViewStation EX, ViewStation FX, and VS4000

What's New in Release 6.0?

New Commands

2
New and enhanced API commands in 6.0 provide greater control over system
behaviors. For example, the system now provides registration data to the
control device when call states, camera states, and certain other states
change. States of registered system parameters are preserved through
system restarts. Registered parameters also now report their current state as
well as registering to report future changes.
The new commands and the commands that have been enhanced in
Release 6.0 are listed in the tables in this section.
The following table lists the new commands in Release 6.0.
Note Shortcuts are no longer allowed for new commands. All shortcuts
that were available in Release 5.0 are still available.
Command
all register, all unregister
OR
registerall, unregisterall
allowcamerapresetssetup
audiotransmitlevel
autoshowcontent
callencryption
dial speeddial
gendialtonepots
getcallstate
ispopupup
isuserinputup
Action
Registers or unregisters commands for all
user feedback. The commands all register or
registerall, which can be used
interchangeably, also return current values.
Sets or gets whether camera presets can be
changed.
Sets or gets the audio volume transmitted to
the far site. It is used to increase the audio
gain level of DTMF dialing tones being sent
to a gateway.
Sets or gets whether content can be shown
when a PC is connected to Visual Concert FX.
Sets or gets the encryption mode (required
when available or disabled).
Dials a Speed Dial entry.
Generates DTMF dialing tones to a POTS line
Gets the state of current calls.
Indicates whether a popup screen is currently
displayed.
Indicates whether a user input screen is
currently displayed.
www.polycom.com/videodocumentation