View Stored Camera Presets With The Remote Control; Store A Camera Preset With The Remote Control; Move The Camera To A Stored Preset With The Remote Control; Audio Adjustments - Polycom RealPresence Group 300 User Manual

View Stored Camera Presets with the Remote Control

You need to be familiar with the stored camera presets to get the most out of your system.
To view stored presets:
1 Using your remote control, press
2 On the local interface, navigate to Cameras > Presets.
Icons for presets 0-9 are shown on the screen. A snapshot above the number means that a preset
has been assigned to that number. An empty box means that no preset has been assigned to that
number.

Store a Camera Preset with the Remote Control

You cannot delete a preset.
Instead, overwrite an existing preset with a new camera position.
To store a preset:
1 If you are in a call, press
On the local interface, navigate to Cameras > Presets.
2 Select Near or Far camera.
3 If you selected a camera that supports electronic pan, tilt, and zoom, you can adjust the camera's
position using your remote control:
 Press
or
 Press the directional buttons to move the camera up, down, left, or right.
4 To store a preset position, press and hold a number from 0 to 9 for five seconds.
Any existing preset stored at the number you entered is replaced.

Move the Camera to a Stored Preset with the Remote Control

After you have your presets stored, move the camera to one of the stored presets.
To move the camera to a stored preset using the remote control:
1 If you are in a call, press Select on the remote control to switch between a near-end site (Your
Camera) or far-end site (Their Camera) camera.
2 Press a number on the remote control.

Audio Adjustments

You can control several audio settings on your RealPresence Group system and control devices. However,
it is important that you do not move the microphones as this might detract from the audio quality.
Polycom, Inc.
.
.
to zoom the camera out or in.
38