View Stored Presets With The Remote Control; Store A Preset With The Remote Control; Move The Camera To A Stored Preset With The Remote Control; Audio Adjustments - Polycom realpresence group series User Manual

● When in a call, selecting near camera control pans and zooms the local camera without changing the
layout.
● When out of a call, selecting camera control changes the Self View to full screen.
● Incoming calls override the full-screen Self View layout.

View Stored Presets with the Remote Control

You need to be familiar with the stored camera presets to get the most out of your system.
To view stored presets:
» Using your remote control, press
Presets. Icons for presets 0-9 are shown on the screen. A snapshot above the number means that a
preset has been assigned to that number. An empty box means that no preset has been assigned to
that number.

Store a Preset with the Remote Control

You cannot delete a preset. Instead, overwrite an existing preset with a new camera position.
To store a preset:
1 If you are in a call, press Select to choose Your or Their camera.
2 If you selected a camera that supports electronic pan, tilt, and zoom, you can adjust the camera's
position using your remote control:
 Press
or
 Press the directional buttons to move the camera up, down, left, or right.
3 To store a preset position, press and hold a number from 0 to 9 for five seconds.
Any existing preset stored at the number you entered is replaced.

Move the Camera to a Stored Preset with the Remote Control

After you have your presets stored, move the camera to one of the stored presets.
To move the camera to a stored preset using the remote control:
1 If you are in a call, press Select on the remote control to switch between a near-end site (Your
Camera) or far-end site (Their Camera) camera.
2 Press a number on the remote control.

Audio Adjustments

You can control the following audio settings on your RealPresence Group system:
Adjust the Volume
Mute the Microphone
Stereo Audio in Video Calls
Polycom, Inc.
and then on the local interface, navigate to Cameras >
to zoom the camera out or in.
24