Adjusting The Fold Mirror - Christie M RGB Series Installation And Setup Manual

Adjusting the fold mirror

Fold mirror adjustment must be completed by trained personnel.
Notice. If not avoided, the following could result in property damage.
• Misalignment of the fold mirror may cause permanent damage to the product.
1. Set the projector to less than 30% brightness.
2. From the Test Pattern menu, select the Integrator Rod test pattern.
3. Loosen the six screws securing the top cover.
Two screws are located at the front of the projector and four screws are located at the rear of
the projector.
4. Slide the top cover forward to release it and remove the cover.
5. To make horizontal adjustments, adjust the 2.5 mm hex screw labeled H FOLD (A in the image
below).
Christie M RGB Series Installation and Setup Guide
020-103483-04 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
34