Table of Contents
Advertisement
Stratasys J826 User Guide
Post-Printing Treatment
Post-printing treatment is recommended for 3D prints with several special-
purpose materials or for special applications. Recommendations for treating
and finishing 3D prints after printing are described in the Best Practices for the
desired printing material available on the
Photobleaching for Transparent 3D Prints
3D prints fabricated with clear materials, such as VeroClear (RGD810) and
and VeroUltra Clear (RGD820) have a slight yellow tint when removed from the
printer. This is especially true for 3D prints with a glossy finish. The yellow tint
fades naturally over time, but you can greatly accelerate this process by using
a suitable photobleaching treatment. This involves exposing 3D prints to
intense light immediately after printing.
Photobleaching methods and instructions are described in the Best
Practices for the relevant clear material. These are available on the
Transparent materials page on the Stratasys Support
Refer to the Best Practices for:
VeroClear RGD810
l
VeroUltra Clear RGD820
l
Storing 3D Prints
3D prints are cured as they are printed, making them safe and stable for a long
time. However, proper storage conditions are necessary to prevent deforming.
• Keep 3D prints at room temperature and in a low-humidity environment.
• Do not expose 3D prints to direct sunlight and other heat sources.
DOC-28000 Rev. I
5 Handling Printed Models
Stratasys Support
Center.
Center.
5-5
Advertisement
Table of Contents
