Post-Printing Treatment; Photobleaching For Transparent Models; Storing Models - Stratasys J4100 User Manual

Stratasys J4100 User Guide

Post-Printing Treatment

Post-printing treatment is recommended for models printed with several special-
purpose materials or for special applications. Recommendations for treating and
finishing models after printing are described in the Best Practices for the desired
printing material available on the

Photobleaching for Transparent Models

Models printed with clear materials, such as VeroClear (RGD810) and VeroUltra
Clear (RGD820) have a slight yellow tint when removed from the printer. This is
especially true for models printed with a glossy finish. The yellow tint fades
naturally over time, but you can greatly accelerate this process by using a
suitable photobleaching treatment. This involves exposing models to intense light
immediately after printing.
Photobleaching methods and instructions are described in the Best Practices
for the relevant clear material. These are available on the
materials page on the Stratasys Support
Refer to the Best Practices for:
l

Storing Models

Models are cured as they are printed, making them safe and stable for a long
time. However, proper storage conditions are necessary to prevent deforming.
• Keep printed models at room temperature and in a low-humidity environment.
• Do not expose models to direct sunlight and other heat sources.
DOC-26000 Rev. C
VeroClear RGD810
Stratasys Support Center.
Center.
5 Handling Printed Models
Transparent
5-5