Operating & Maintaining the Objet30 3D Printer
Replacing the
Odor Filter
6–38
If the printer exhaust is not connected to an external ventilation system, a
built‐in activated‐carbon filter removes odors from printing materials. This
filter should be replaced regularly (about once a year, as necessary) to keep
your working environment pleasant. This is normally done during the
yearly preventive‐maintenance service visit.
To replace the odor filter:
1. Locate the filter drawer at the rear of the printer and pull it open.
Figure 6-56: Rear of the Objet30 printer
2. Remove the used filter. (You can push it out from underneath the
drawer.)
Figure 6-57: Odor filter in drawer
3. Insert a new filter and close the drawer.
Odor filter drawer
DOC-24333 Rev. A