Setting The Remote Printer Connection (Client Mode); Job Manager Commands - Stratasys Objet30 User Manual

Setting the
Remote Printer
Connection
(Client Mode)
Job Manager
Commands
DOC-24333 Rev. A
When you open Objet Studio for the first time in a client installation, you
are prompted to connect to an Objet server computer that sends jobs to a 3D
printer. To do this, the server computer must be operating and connected to
the local network.
To set (or change) the connection to the server-computer:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. Enter the name of the server computer or its IP address, or click
to find and select it.
Browse
3. Click .
OK
Figure 5-91: Printer Server Connection dialog box
The Job Manager ribbon has three icon groups:
•
3D Printer
•
Queue
•
Job
Figure 5-92: Job Manager ribbon commands
Icons are enabled or disabled according to their relevancy. For example,
you cannot stop printing a job that is not being printed, so the Stop
command is disabled.
Objet30 User Guide
.
5–63