Table of Contents
Advertisement
Removing the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack.
•
•
Remove the server from the rack.
5. Remove the access panel.
6. Remove the air baffle.
Installing the air baffle
Procedure
1. Observe the following alert.
Operations
33
Advertisement
Table of Contents
