Note – The factory has configured the service processor hardware and firmware on
your server with the most common settings used in the field. You may not need to
change these defaults.
See the Embedded Lights Out Manager (ELOM) Administration Guide for detailed
information.
Connecting the Cables
Connect the power and data cables from the server back panel to your system.
Connector Locations
See
FIGURE 3-1
Back Panel Connectors
FIGURE 3-1
Back Panel Connector Legend
TABLE 3-2
Label
Item
1
Power supply unit 0 connector
2
Power supply unit 1 connector
3
System status LEDs
4
Serial management/RJ-45 serial port
and
for the locations of the back panel connectors
TABLE 3-2
Label
5
6
7
8
Item
Service processor (SP) network management NET
MGT Ethernet port
Gbit Ethernet ports LAN-0, 1, 2, 3 (Intel)
USB 2.0 ports (0, 1)
HD15 video connector
Chapter 3 Setting Up the Sun Fire X4150 Server
.
31