Dual Temperature Sensor Module (Dtsm) - Christie Cinema 4K-RGB Service Manual

10. Remove and replace the HUB-NX.
11. To re-install, follow these steps in reverse order.

Dual temperature sensor module (DTSM)

The dual temperature sensor module (DTSM) monitors the ambient air temperature going into the
projector.
1. Remove the side-intake cover (on page 41).
2. Disconnect the DTSM inline harness connector F and connector J82.
3. Remove the screw securing the DTSM.
4. Replace the DTSM.
5. To re-install, follow these steps in reverse order.
Cinema 4K-RGB Service Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102713-06 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Printed circuit boards and sensors
90