EDAN elite V5 User Manual page 89

Patient Monitor User Manual
Message
AG Changing to Meas.
AG Agent Low Concentration
AG Agent Calculate
AG Agent Estimated
AG Agent Overflow
BIS Sensor Check - Not Pass Yet
BIS Ground Check
Reconnect BIS Device
RM Module Purge In Progress
RM Module Zero In Progress
RM Zero Required
Initializing ICG
ICG No Measurement Started
Printer Busy
No Default Printer
Into data...
Recorder Setup Needed
NMT Calibration OK
Incomplete parameter
unable to score
SpO Noisy Signal
2
Inconsistent patient type (XX)
XX represents one of the external
devices, LiDCO, Ventilator or
Anesthetic device
Cause
Work Mode is switching to Measure from Standby.
Measured agent concentration is low.
Usually it comes up if no single agent history is available
and a mixture situation occurs.
The AG module cannot identify the present agent(s) but
only give an estimation of one of the present agents. The
reason is the presence of either a mixture or too many
anesthetic.
The gas concentration has increased above the maximum
threshold.
A sensor check is in progress.
Impedance check for the ground electrode is in progress.
The module has stopped or the BISx device is not
connected.
A purge operation of the flow sensor is in progress.
The zero calibration of RM module is in progress.
Malfunction
transducer or airway pressure transducer
The ICG module is being initialized.
ICG module is not ready to start measurement.
The monitor is performing a print job.
No default printer has been set.
iM20 is transferring data into the monitor.
The user presses the RECORD button or shortcut key
Record when Recorder is not configured.
External device calibration OK.
input,
In MEWS interface, parameters are not completely input.
There is interference with SpO
to patient
interference or else. (Nellcor SpO
If the patient information on external device is
inconsistent with that on the monitor
- 74 -
in zeroing the
measurement signals due
2
movement, ambient
2
Alarm Information
differential pressure
light, electrical
module)