EDAN elite V5 User Manual page 38

Patient Monitor User Manual
1 Speaker
2 Equipotential
grounding terminal
3 Power
latch
4 AC power input
5 SD card slot
6 VGA output
7 USB interfaces
8 Nurse call port/analog
output/defibrillator
synchronization
9 Network interface
10 Extended
interface
11 PAM connector
12 RS232 interface
13 Heat sink
14 Anti-thief lock
Connect only the EDAN Parameter Amplifier Mainframe to the PAM connector. Do not
connect any other device to this connector.
cable safety
video
For alarm tones, pulse tones and so forth.
If the monitor is used together with other
devices, connect this terminal to eliminate
potential ground differences between devices.
Used to prevent the power cable from loosing
or falling. Place the latch on the power cable
and press it down firmly to ensure that it
secures the power cable.
Used to mount an SD memory card.
It enables the VGA video output.
They support USB1.0/2.0 output.
If users select it as nurse call, it connects the
monitor to the hospital's nurse call system.
Alarms indications are alerted through the
nurse call system if configured to do so. If
users select it as analog output, the monitor
outputs the waveform through the port.
It connects the monitor to the central
monitoring system via standard network cable.
It connects a secondary display, which extends
the display capability of your monitor.
It connects
Mainframe to the monitor.
Connect it to communicate with other devices.
CAUTION
- 23 -
Basic Operation
the Parameter Amplifier