EDAN elite V5 User Manual page 87

Patient Monitor User Manual
Message
ECG ARR Learning
ExtremeTachy Off
ExtremeBrady Off
V-Tach Off
Vent Brady Off
Key ARR Alarm Off
SpO Search Pulse
2
NIBP Simul
Manual Measuring
Continual Measuring
Auto Measuring
Measurem. Canceled
Calibrating
Calibrat. Canceled
Leak. Test Running
Leak.Test Canceled
Resetting
Please Start
Done
CO Standby
2
CO Sensor Warms Up
2
CO Zero Start
2
CO Zero OK
2
No module detected
No module activated
Loading module...
Please Press 'Zero'.
Cause
The QRS template building required for Arr. Analysis is
in process.
Extreme Tachycardia alarm is set to Off.
Extreme Bradycardia alarm is set to Off.
V-Tach alarm is set to Off.
Vent Brady alarm is set to Off.
One of Key ARR alarms is set to Off.
SpO module is analyzing the patient signal and
2
searching for the pulse to compute the saturation, when
sensor is connected with patient.
NIBP Simul function is turned on.
In manual measuring mode.
In continuous measuring mode.
In automatic measuring mode.
Press the "Start/stop NIBP measurement" button or
shortcut key to stop the measurement.
During calibrating
Calibration is over.
The leakage test is in process.
Pneumatic test over
NIBP module in resetting
NIBP module is in idle status
NIBP measurement is completed.
Switch from measuring mode to standby mode, making
the module in energy-saving status.
The CO module is in warm-up state
2
CO module starts zero calibration.
2
CO module completes zero calibration.
2
No module is mounted in the monitor.
No module is activated.
The system is loading the inserted module.
Enter the IBP zeroing menu, and zeroing is not
performed yet.
- 72 -
Alarm Information