EDAN elite V5 User Manual page 74

Patient Monitor User Manual
Message
NIBP Interference
NIBP Leak Test
Error
TEMP
TEMP T1 Sensor Off
TEMP T2 Sensor Off
Excessive T1
Excessive T2
TEMP Comm Fail
T1 Calibration
Failed
T2 Calibration
Failed
IBP
YY Sensor Off (YY
stands for the IBP
label name: Art, PA,
CVP, RAP, LAP, ICP,
P1 and P2)
Cause
Signal noise is too large or
pulse rate is not regular due
to the patient movement.
Fail to deflate normally
during the leak test, so
NIBP leak test cannot be
finished.
Temperature cable of TEMP
channel1 may
disconnected from
monitor.
Temperature cable of TEMP
channel2 may
disconnected from
monitor.
TEMP1 measuring value is
beyond measuring range.
TEMP2 measuring value is
beyond measuring range.
TEMP module failure or
communication failure.
T1 calibration failed.
T2 calibration failed
IBP sensor falls off.
Alarm Level
Low
Low
be
Low
the
be
Low
the
High
High
High
High
High
Medium
- 59 -
Alarm Information
Action Taken
Make sure that the
patient under
monitoring is
motionless.
Test again. If the
problem still exists,
contact your service
personnel.
Make sure that the
cable is properly
connected
Make sure that the
cable is properly
connected.
Check sensor
connection and
patient condition
Stop measuring
function of TEMP
module, and notify
biomedical engineer
or Manufacturer's
service staff.
Please check
whether the module
works properly.
Check the sensor
connection and
reconnect the sensor.