EDAN elite V5 User Manual page 85

Patient Monitor User Manual
Message
NMT Temp. Value
Out Of Range
PTC error
Other external devices
XX Comm. Failed
(XX represents one of
the external devices
connected.)
V-Link Abnormity
Others
Battery Low
Battery1 Error
Battery2 Error
Recorder Out
Paper
Recorder Probe
Overheated
Cause
External device's
sensor signal over flow and
exceed rated measurement
range.
In PTC mode, the patient
response in
stimulation.
External module failure or
communication failure.
Communication
between monitor
V-Link.
Battery Low
Malfunction in Battery 1
Malfunction in Battery 2
Of
Recorder Out Of Paper
The probe of recorder is
overheated.
Alarm Level
temp
Low
the first Low
High
failure Medium
and
High
Low
Low
Low
Low
- 70 -
Alarm Information
Action Taken
Make sure temp
sensor is well
connected and
temperature is
within measurement
range,
Check the patient
response and drug
dose is proper.
Unplug the V-Link
module, insert the
serial port cable, and
then reinsert V-Link
module. If the
problem still exists,
please notify
biomedical engineer
or manufacturer's
service staff.
Please contact the
manufacturer and
replace V-Link
module.
Change the batteries
or charge the
batteries.
Replace the battery
and restart the
monitor. If the
problem persists,
notify the
manufacturer's
service staff.
Please install the
paper
Stop recording and
retry after the probe
cools.