Smc40 Sensor Module Cabinet (Only For Direct Measuring Systems); Communication Board Ethernet Cbe20 - Siemens SINAMICS S120 Commissioning Manual

6.1.3.4

SMC40 Sensor Module Cabinet (only for direct measuring systems)

Table 6-28 Meaning of the LEDs on the Sensor Module Cabinet-Mounted SMC40
LED Color
RDY –
READY
Green
Orange
Red
Green/red
Green/
orange
or
Red/
orange
The parameters for activating component recognition can be taken from the following reference:
1)
Reference: SINAMICS S120/S150 List Manual
Each channel has a multifunction LED.
6.1.3.5

Communication Board Ethernet CBE20

Table 6-29 Meaning of the LEDs at ports 1 to 4 of the X1400 interface
LED Color
Link port –
Green
Activity –
port
Yellow
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Status Description, cause
Off The electronics power supply is missing or outside the permis‐
sible tolerance range.
Continu‐ The component is ready for operation. Cyclic DRIVE-CLiQ com‐
ous light munication is taking place.
Continu‐ DRIVE-CLiQ communication is being established.
ous light
Continu‐ This component has at least one fault.
ous light
Note:
LED is controlled irrespective of the corresponding messages
being reconfigured.
Flashing Firmware download is complete. The system waits for POWER
light ON.
2 Hz
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component rec‐
ognition is activated.
Status Description
Off The electronics power supply is missing or outside the permissible tolerance range (link
missing or defective).
Continu‐ A different device is connected to port x and a physical connection exists.
ous light
Off The electronics power supply is missing or outside the permissible tolerance range (no
activity).
Flashing Data is being received or sent at port x.
light
6.1 Diagnostics using LEDs
Remedy
–
–
–
Correct and acknowl‐
edge the fault.
Carry out a POWER ON.
. –
1)
Diagnostics
301